(Click Category to List Courses)
19 - EEE - Electrical & Electronics Engineering
EEE 123 - Cable Termination
| Code | Start Date | Duration | Venue | |
|---|---|---|---|---|
| EEE 123 | 22 April 2024 | 5 Days | Istanbul | Registration Form Link |
| EEE 123 | 27 May 2024 | 5 Days | Istanbul | Registration Form Link |
| EEE 123 | 01 July 2024 | 5 Days | Istanbul | Registration Form Link |
| EEE 123 | 05 August 2024 | 5 Days | Istanbul | Registration Form Link |
| EEE 123 | 09 September 2024 | 5 Days | Istanbul | Registration Form Link |
| EEE 123 | 14 October 2024 | 5 Days | Istanbul | Registration Form Link |
| EEE 123 | 18 November 2024 | 5 Days | Istanbul | Registration Form Link |
| EEE 123 | 23 December 2024 | 5 Days | Istanbul | Registration Form Link |
Course Description
Splices and terminations, which are always a vital part of any cable system, become more susceptible to failure at higher voltages. Whether splicing or terminating is accomplished by the use of hand-applied tapes, a filled or molded device, heat-shrinkable tubing, or a prefabricated device, care should be exercised during the application. Poor workmanship or improper choice of materials could jeopardize the reliability of the entire system. This course covers distribution underground cable accessories from low to high voltage cable from various manufacturers. The course is designed according to the type of cable and cable accessories utilized by participants' companies.
Course Objectives
- Identifying the causes of splice and termination failures
- Utilizing a DC high potential tester for performing dielectric strength tests on assembled splices
- Preparing cable for splicing utilizing hand tools, abrasives and solvents
- Installing taped, cold shrink and molded elbow terminations
Who Should Attend?
- Engineers
- Electricians
- Supervisors
- Those involved in the installation, maintenance, splicing and terminating of Low-High voltage cable systems
Course Details/Schedule
Day 1
Introduction
- Medium Voltage Splicing and Termination
- Types of High Voltage Cables
- High Voltage Cable Components
Cable Preparation
- Safety Procedures
- Hand Tools
- Abrasives and Solvents
- Supplies and Materials
- Cable Preparation Procedures
Day 2
Terminations
- Modular
- Molded
- Tape Systems
- Shrink Technologies
- Other
Cable Installation and Handling
- Environmental Protection
- Light, Power and Ventilation
- Housekeeping E. Cable Handling
- Direct Bury
- Duct and Tray Installation
- Causes of Cable Failures
Day 3
Cable Splicing and Terminating Technologies and Standards
Splicing Technology
- Modular
- Molded
- Tape Systems
- Shrink Technologies
- Other
Cable Splicing
Molded Splice
- Cable Preparation
- Review Splicing Instructions
- Molded Splicing Installation
Taped Splice
- Cable Preparation
- Review Splicing Instructions
- Taped Splicing Installation
Day 4
Heat Shrink Splice
- Cable Preparation
- Review Splicing Instructions
- Heat Shrink Splicing Installation
Cable Terminations
Cold Shrink Termination
- Cable Preparation
- Review Termination Instructions
- Cold Shrink Termination
Day 5
Elbow Termination
- Cable Preparation
- Review Termination Instructions
- Elbow Termination Installation
Cable Testing Methods
- Insulation Resistance
- DC Hipot
- Very Low Frequency Testing
- Partial Discharge Testing
- Power Factor Testing
